Cylinder - Honda LEAD 110 2009 Service Manual

BRAKE SYSTEM
Coat the master piston, spring and piston cups with
Replace the piston,
brake fluid.
cups, spring, snap
ring and boot as a
Install the spring onto the master piston end.
set; do not substi-
tute individual
parts.
Install the spring/master piston into the master cyl-
Do not allow the
inder.
piston cup lips to
turn inside out.
Install the snap ring into the groove of the master

cylinder.

TOOL:
Snap ring pliers
Apply 0.1 g of silicon grease to the inside of the
boot.
Install the boot into the master cylinder until it is
fully seated on the snap ring and set its lip into the
groove of the master piston.
Apply silicone grease to the brake lever contacting
surface of the master piston.
Install the brake light switch by aligning the boss of
the switch body and hole of the master cylinder.
Install and tighten the screw to the specified torque.
TORQUE: 1.2 N·m (0.12 kgf·m, 0.9 lbf·ft)
17-14
MASTER PISTON
07914-SA50001
SNAP RING
Align
BRAKE LIGHT SWITCH
SPRING
CUPS
SNAP RING
SNAP RING PLIERS
BOOT
GROOVE
BOOT
SCREW