Honda LEAD 110 2009 Service Manual page 315

FRONT WHEEL/SUSPENSION/STEERING
Install the bearing remover head into the bearing.
Do not reuse the
From the opposite side of the wheel, install the
old bearings.
bearing remover shaft and drive the bearing out of
the wheel hub.
TOOLS:
Bearing remover shaft
Bearing remover head, 12 mm
Remove the distance collar and drive out the other
bearing.
INSPECTION
AXLE
Place the axle in V-blocks and measure the runout.
Actual runout is 1/2 the total indicator reading.
SERVICE LIMIT: 0.2 mm (0.01 in)
WHEEL BEARING
Turn the inner race of each bearing with your finger,
the bearings should turn smoothly and quietly.
Also check that the bearing outer race fits tightly in
the hub.
Remove and discard the bearings if the races do not
Replace the wheel
turn smoothly, quietly, or if they fit loosely in the
bearings in pairs.
hub.
15-8
07746-0050100
07746-0050300
BEARING
REMOVER SHAFT
WHEEL BEARING
REMOVER
HEAD
REMOVER SHAFT
REMOVER
HEAD
REMOVER
HEAD
BEARING
AXLE