Honda LEAD 110 2009 Service Manual page 268

MOVABLE DRIVEN FACE
Check the movable driven face for scratches, scor-
ing or damage.
Check the guide grooves for stepped wear or dam-
age.
Measure the movable driven face I.D.
SERVICE LIMIT: 34.06 mm (1.341 in)
DRIVEN FACE BEARING INSPECTION
Also check that the bearing outer race fits tightly in
the driven face.
Install the driven face to the driveshaft.
Turn the driven face with your finger. The bearing
should turn smoothly and quietly.
Replace the bearings if they do not turn smoothly,
quietly, or if they fit loosely on the driven face (page
11-17).
DRIVEN FACE BEARING REPLACE-
MENT
Remove the driven face needle bearing using the
special tools.
TOOLS:
Bearing remover, 20 mm
Fork seal driver attachment
Remove the snap ring and drive the ball bearing out
of the driven face.
DRIVE PULLEY/DRIVEN PULLEY/CLUTCH
DRIVEN FACE
07931-MA70000
07747-0010400
BALL BEARING
SNAP RING
BEARING REMOVER
FORK SEAL DRIVER
ATTACHMENT
NEEDLE BEARING
11-17