Mediaport 300 Initiated Messages - Extron electronics MediaPort 300 User Manual

To log in to the MediaPort 300 via Ethernet or IP over USB:
• User name = admin or user
Password = <unit serial number> if the unit is new, extron if the unit has had an
•
absolute system reset.

MediaPort 300 Initiated Messages

Power-up
When the MediaPort 300 completes its start-up, it issues the following message to the host:
©
Copyright 20yy
<date> and <time>
. is the firmware version number and
Vx xx
Local events
When an event such as an input rate change or audio status change takes place, the
MediaPort 300 responds by sending a message to the host. No response is required from
the host. Examples of local event messages are listed here.
]
Reconfig
The MediaPort 300 sends this response when a change in the HDMI input signal is
detected.
]
HplgO
The MediaPort 300 sends this response when a hot plug event on the output is detected
(for example, when a display on the HDMI loop output is unplugged and reconnected).
X1^
•
40Stat
The MediaPort 300 sends this response when the audio status changes.
input type and
X1#]
SsavS
The MediaPort 300 sends this response when the screen saver status changes.
X1#
= Screen saver mode (see
X2! X2@]
*
Rate
The MediaPort 300 sends this response when the USB video streaming resolution changes.
X2!
= USB output resolution group and
Y@]
Host
The MediaPort 300 sends this response when there is a change in the USB host connection
X@
status.
MediaPort 300 HDMI and Audio to USB Scaling Bridge • Remote Configuration and Control
,
Extron Electronics
]
X1&]
*
X1&
= USB audio type (see
page 56).
= Connected (1) or disconnected (0).
, , . , -
MediaPort 300 Vx xx 60 nnnn
- - is the part number.
60 nnnn nn
page 56).
X2@
= Output resolution and rate (see
-
nn ]
X1^
= HDMI audio
page 57).
51