Table of Contents
Advertisement
Basic Operation
Powering On
Apply power by connecting the external power supply to the Power connector (see
figure
the LAN/PoE+ connector (
Reset operations
The rear panel RESET button initiates three levels of resets. The RESET button is recessed,
so use a pointed stylus, ballpoint pen, or Extron Tweeker to access it.
See the
ATTENTION:
NOTES:
MediaPort 300 HDMI and Audio to USB Scaling Bridge • Installation and Basic Operation
I
7,
on page 14) or by applying an appropriate PoE+ enabled LAN connection to
G
).
table
on page 22 for a summary of the modes.
•
Review the reset modes carefully. Using the wrong reset mode may result in
unintended loss of flash memory programming, port reassignment, or a controller
reboot.
•
Étudier de près les différents modes de réinitialisation. Appliquer le mauvais mode
de réinitialisation peut causer une perte inattendue de la programmation de la
mémoire flash, une reconfiguration des ports ou une réinitialisation du contrôleur.
•
The factory configured passwords for all accounts on this device have been set to
the device serial number. In the event of a complete system reset, the passwords
convert to the default, which is extron.
•
The modes listed close all open IP and Telnet connections and close all sockets.
21
Advertisement
Table of Contents
