Table of Contents
Advertisement
Connecting for Remote Control
The MediaPort 300 can be connected to a computer for configuration, control, and firmware
update (see
•
•
Configure the MediaPort 300 as desired, using PCS (see
Software
page 50).
Configuring Windows for MediaPort 300
NOTES:
The host PC or Mac OS device detects the MediaPort 300 and installs generic USB UVC
(universal video codec) and UAC (universal audio codec) drivers, a process known as
"enumerating", with the host PC in either of the following modes:
•
•
Configure the MediaPort 300 as follows:
1.
2.
3.
4.
5.
MediaPort 300 HDMI and Audio to USB Scaling Bridge • Installation and Basic Operation
Updating Firmware via PCS
Rear panel LAN/PoE+ port (see
connection instructions found in
USB Config port (see
figure 13
on page 26 or SIS commands (see
•
In this guide, the following steps are performed with the MediaPort 300 in the
default mode of enumerating as a Non-Echo Cancelling Speakerphone &
Webcam
.
If the MediaPort 300 is configured as an Echo Cancelling Speakerphone &
•
Webcam (when used with external DSP with AEC) the steps are the same. However,
Windows enumerates the MediaPort 300 as Echo Cancelling Speakerphone
not Speakerphone as shown in the following steps.
Non-Echo Cancelling Speakerphone & Webcam (default) — Sets the
MediaPort 300 to Speakerphone as described in this section.
Echo Cancelling Speakerphone & Webcam (using external DSP with AEC) — Sets
the unit to Echo-cancelling Speakerphone using the Hardware Settings screen.
Applicable when the MediaPort 300 is used with a DSP with AEC.
Connect a USB-C cable from the MediaPort 300 rear panel Host port to a USB port on
a Windows PC. The required drivers install automatically. A message notifies you when
driver installation is complete.
NOTE: Extron recommends connecting to a USB 3.x / SuperSpeed port to ensure
the best audio and video performance (see
recommendations.
On the Microsoft
Windows taskbar, right-click the speaker icon (see
®
page 24) and select Open Sound Settings (
dialog box opens.
Click the Choose your output device drop down menu and select Speakerphone
Extron (MediaPort 300) (
Click the Choose your input device drop down menu and select Speakerphone
Extron (MediaPort 300) (
Click X (
5
) to close the Sound dialog box.
on page 30) via the following ports:
figure 7
on page 14 and
TP cable termination
and
on page 20.
A
Product Configuration
Remote Configuration and Control
E
on page 15 for detailed cable
2
) from the pop-up menu. The Sound
3
).
4
).
on page 15 and follow
G
on page 18).
on
figure
15,
1
on
23
Advertisement
Table of Contents
