7.
8.
Front Panel Indicators
CONFIG
A
A A
Figure 16.
A
B
C
Configuring Windows for Various Applications
For additional soft codec configurations, see the MediaPort Soft Codec Configuration
Guide, available at www.extron.com.
MediaPort 300 HDMI and Audio to USB Scaling Bridge • Installation and Basic Operation
Click the Input tab (
5
).
Click Extron MediaPort 300 from
the Select a device for sound
input drop-down menu (
6
HDMI STATUS
SIGNAL IN
LOOP OUT
HDCP IN
LOOP HDCP
B B
B
MediaPort 300 Front Panel Features
Power LED — Indicates the unit is receiving power.
HDMI STATUS LEDs —
•
SIGNAL IN LED — An active HDMI input signal is present.
•
HDCP IN LED — The received input signal is HDCP encrypted.
LOOP OUT LED — A sink is detected from the HDMI Loop Out connector.
•
•
LOOP HDCP LED — The signal output on the HDMI Loop Out connector is HDCP
encrypted.
USB STATUS LEDs — Indicate the connection and signal status of the rear panel USB
port as follows:
•
HOST — The rear panel USB port is connected to and enumerated with the host
computer.
NOTE: The HOST LED blinks when connected to a USB bus that is in the
'suspend' state, which is common with some USB hub, extension, or
switching devices as well as with ChromeOS devices.
VIDEO SEND — A video signal is being output to the host via USB.
•
AUDIO SEND — An audio signal is being output to the host via USB.
•
•
AUDIO RETURN — Audio input is being received from the host via USB.
).
6 6 6 6
6 6 6 6 6 6 6 6
6 6 6 6 6 6
USB STATUS
HOST
VIDEO SEND
AUDIO RETURN
AUDIO SEND
C
C C
5 5 5 5
5 5 5 5 5 5
5 5 5 5 5 5 5 5
MediaPort 300
25