To Change Jumpers (Manual Balance Model) - KYOWA WGA-120A Instruction Manual

2-1 TO CHANG GE JUMPERS (MANUAL
① Disconnect the e power cable.
② Remove 4 flat t head screws (M2.6) locat
side panels. R Remove the cover.
③ Change the jum mpers (JP1 to JP8) on the
settings. For J JP1 to JP8 locations on the
④ Mount the cov ver by fastening 4 flat head
on the WGA- 120A side panels.
L BALANCE MODEL)
ted on the WGA-120A
PCB to your desired
e PCB, see page 20.
d screws (M2.6) located
[Example]
Bridge excitatio
Output signal
Sensitivity
CAL
Frequency resp
-17-
Remove screws (on b
on voltage 2 Vrms
Voltage
×10000
0.25mV/V
ponse 10 Hz
both sides).
(350 ohm)