KYOWA WGA-120A Instruction Manual page 12

Do not disassemble or remodel the WGA-120A.
It may cause electric shock hazards or damage the WGA-120A. This warranty does not cover any
damaged or defective parts that results from disassembling or remodeling.
The output signal (voltage/current) when the transducer cable is broken.
When the transducer cable is broken, the WGA-120A may output the following output signal
(voltage/current). Therefore, take countermeasures to avoid the adverse effect, from the output signals,
on the other measuring instruments.
Output signal (voltage):
Output signal (current):
The output signal (voltage/current) and unbalance load
Output signal (voltage):
Output signal (current):
Location
Use the WGA-120A within temperature ranging from -10 to 50℃ and within humidity ranging from 20
to 85%RH.
Do not use the WGA-120A under environment with excessive vibration or high impact, under dusty
environment, and under humid place. Or, it may lower the performance and cause troubles.
Cleaning
When the product gets dirty, clean the product with a dry soft cloth. When dust exists inside the
WGA-120A, clean it by using an air blow gun. Do not touch electronic parts.
Around -13 V
Around 0m A
The unbalance load should be 2k ohm or more.
The unbalance load should be 500 ohm or less.
-7-