4-6.5.3. Super Io Device - SOLTEK SL-K8T-939FL Manual

SL-K8T-939FL

4-6.5.3. Super IO Device:

To press< Enter > on Super IO Device will reveal the following items.
Onboard FDC Controller
Onboard Serial Port 1
Onboard Serial Port 2
UART Mode Select
x UR2 Duplex Mode
Onboard Parallel Port
Parallel Port Mode
x ECP Mode Use DMA
Onboard FDC
Controller
Onboard Serial
Port 1 / Port 2
UART Mode Select The serial port on your system may offer a vari-
x UR2 Duplex Mode This options controls the operating mode between
Onboard Parallel Port This item allows you to determine onboard parallel
Parallel Port Mode Select an operating mode for the on-board parallel
x ECP mode Use DMA Select a DMA channel for the port when you choose
Enabled
Auto
Auto
Normal
Half
378/IRQ7
SPP
3
To enable/disable the onboard Floppy Disk Drive
Controller.
Select an address and corresponding interrupt
for the first/second serial port.
Choices: Disabled; Auto;
3F8/IRQ4; 2F8/IRQ3;
3E8/IRQ4; 2E8/IRQ3
ety of infrared port modes. Click here for a de-
scription of various modes.
The choices: Normal; IrDA; ASKIR; SCR
receiving and transmitting of IrDA or ASKIR or SCR.
Choices: Half (asynchronous); Full (synchronous)
port controller I/O address setting.
Choices: 378H/IRQ7; 278H/IRQ5; 3BC/
IRQ7; Disabled
(printer) port.
Choices: SPP; EPP; ECP; ECP+EPP
ECP or ECP+EPP mode for the Parallel Port Mode.
Choices: 1; 3
63
Chapter 4 BIOS Setup
Item Help