Table of Contents
Advertisement
SL-K8T-939FL
VIA OnChip IDE Device:
To press< Enter > on VIA OnChip IDE Device will reveal following item.
OnChip SATA To enable/disable the SATA interface.
SATA Mode To select the SATA Mode.
IDE DMA transfer
On-Chip IDE Channel
IDE Prefetch Mode The on-board IDE drive supports IDE prefetching
Master / Slave PIO
Secondary
Master / Slave PIO
Master / Slave UDMA
Secondary
Master / Slave UDMA
IDE HDD Block Mode Block mode is also called block transfer, multiple
Choices: IDE; RAID
To enable/disable the IDE direct memory access
access
transfer function.
The chipset contains a PCI IDE interface with
10/11
support from two IDE channels. Select Enabled
to activate the first and/or the second IDE
interface. Select Disabled to inactivate an inter-
face if you install a primary and/or second add-
on IDE interface.
Choices: Enabled; Disabled
for faster drive accesses. If the IDE device doesn't
support prefetching, set this field to Disabled.
The choices: Enabled; Disabled
Primary
Choose Auto or Mode 0~4. The BIOS will detect the
HDD mode type automatically when you choose
Auto. You need to set to a lower mode than Auto
when your hard disk becomes unstable.
Choices: Auto(default); Mode 0; Mode 1; Mode
Primary
Ultra DMA33/66/100/133 implementation is possible
only if your IDE hard drive supports it, if the operat-
ing environment includes a DMA drive, and if your
system software supports Ultra DMA33/66/100/133.
Select "Auto" to enable BIOS support.
Choices: Auto(default); Disabled
commands, or multiple sector read/write. If your IDE
hard drive supports block mode (most new drives
do), select Enabled for automatic detection of the
optimal number of block read/write per sector the
drive can support.
2; Mode 3; Mode 4
61
Chapter 4 BIOS Setup
Advertisement
Table of Contents
