Removing The M.2 Ssd Module; Installing The M.2 Ssd Module - Dell EMC PowerEdge GPH2C Installation And Service Manual

Next steps
1. If applicable, Install the M,2 BOSS
2. Follow the procedure listed in

Removing the M.2 SSD module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Removing the M.2 BOSS
4. Remove the M.2 BOSS card from the M.2 BOSS
Steps
1. Using the Phillips #1 screwdriver, remove the screws securing the M.2 SSD module to the BOSS card.
2. Pull the M.2 SSD module to disconnect from the connector on the M.2 BOSS card.
Figure 80. Removing the M.2 SSD module
Next steps
1. If applicable, Install the M.2 BOSS card into the M.2 BOSS
2. If applicable, Install the M,2 BOSS

Installing the M.2 SSD module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Removing the M.2 BOSS
4. Remove the M.2 BOSS card from the M.2 BOSS
Steps
1. Align the M.2 SSD module at angle with the connector on the M.2 BOSS card.
2. Insert the M.2 SSD module until it is firmly seated in M.2 BOSS card connector.
riser.
After working inside your
Safety instructions.
Before working inside your
riser.
riser.
riser.
Safety instructions.
Before working inside your
riser.
riser.
system.
system.
riser.
system.
Installing and removing system components 79