Http Service - AutomationDirect StrideLinx SE-SL30011 User Manual

Linx
Chapter 2: StrideLinx Cloud 2.0
Connect to Devices Behind the StrideLinx Router (cont'd)

HTTP Service

If your machine runs an HTTP server, you can access it over the VPN
connection, or you can access it without needing to establish a VPN
connection to your device by setting it up as a service.
Add an HTTP service
1. In the Fleet Manager menu, select Devices
2. Click the Add a service
3. Enter the requested information (details below) and click [Add].
Setting
Name
IP address
Protocol
Port
Default landing
page
Access category
4. You have now made the changes in StrideLinx Cloud, but these are not yet active in your
device. Click [Push config to device] in the top right corner for them to take effect.
Use an HTTP service
1. In the Portal menu, select Devices
2. Make sure the StrideLinx router is online, (has a green dot beside it in the Portal.
3. Click on the name of your HTTP service
StrideLinx™ Cloud 2.0 Industrial VPN Routers User Manual
icon in the left menu and select [HTTP server].
VNC Settings
Name your HTTP service for easy distinction from other services.
The IP address of your machine. Leave empty if you want to access the HTTP server of the router.
The protocol supported by the machine's server: HTTP or HTTPS.
The port number where the HTTP server can be reached. By default it's 80 (for HTTP) or 443 (for HTTPS).
If your machine has a specific page that you want to open by default, you can enter the page name here.
You can find the page name in the address bar after opening it. Leave "/" if you are unsure.
The access category determines who can use this HTTP service. More information about access
categories and how you can create one can be found can be found in
User Management section of this chapter.
, then click the name of your router.
, then click the name of your router.
Description
this online help
in the remote access section.
1st Edition Rev. C
Online Help
article, or in the
2-32