Table of Contents
Advertisement
Linx
Chapter 2: StrideLinx Cloud 2.0
Device Management (cont'd)
Recover device settings after factory reset (recovery mode)
After doing a factory reset, the device may no longer automatically
connect to StrideLinx Cloud, as its network has been reset.
If the device is still listed in StrideLinx and you want to re-use those settings, follow the steps
below and then register your device again.
1.
Go to the Fleet Manager, which is accessible via the Apps menu
corner of your StrideLinx account.
2.
Open the main menu
3.
Go to More
You can now register your device again, and it will retain its previous network settings.
Remove a device from your company
To clean up your company you may decide to remove a router. After
removing a device from your company, it is no longer remotely accessible
and you'll need to register the device again in order to use it again.
To remove a device from your company, please follow the steps described below.
1.
Go to the Fleet Manager, which is accessible via the Apps menu
corner of your StrideLinx account.
2.
Open the main menu
3.
Go to More
4.
A confirmation dialog will display the router name and id, and ask you to verify the
action.
You can now register your device again, and it will retain its previous settings.
StrideLinx™ Cloud 2.0 Industrial VPN Routers User Manual
, select Devices
and select [Use Recovery Mode].
, select Devices
and select [Remove device].
, then click the name of your router.
, then click the name of your router.
1st Edition Rev. C
Online Help
in the top right
Online Help
in the top right
2-27
Advertisement
Table of Contents
Need help?
Do you have a question about the StrideLinx SE-SL30011 and is the answer not in the manual?