Wiring - AutomationDirect StrideLinx SE-SL30011 User Manual

Linx
Chapter 1: Hardware
Guidelines for Installing the StrideLinx Router
When designing the layout of your system, always separate the devices that generate
high voltage and high electrical noise from the low-voltage, logic-type devices such as the
StrideLinx router. Also consider the heat-generating devices and locate the electronic-type
devices in the cooler areas of your cabinet. Reducing the exposure to a high-temperature
environment will extend the operating life of the StrideLinx router.
Consider also the routing of the wiring for the devices in the panel. Avoid placing low-voltage
signal wires and communications cables in the same tray with AC power wiring and high-
energy, rapidly-switched DC wiring.
The StrideLinx router is designed to be cooled using natural convection. For proper cooling,
you must provide a clearance of at least 25 mm [1 inch] above and below the device. Also,
allow at least 25 mm [1 inch] of depth between the front of the device and the inside of the
enclosure.

Wiring

Wiring Guidelines
WARNING: To minimize the risk of potential safety problems, you should follow all applicable local and national
codes that regulate the installation and operation of your equipment. These codes vary from area to area and it is
your responsibility to determine which codes should be followed, and to verify that the equipment, installation,
and operation are in compliance with the latest revision of these codes.
Equipment damage or serious injury to personnel can result from the failure to follow all applicable codes and
standards. We do not guarantee the products described in this publication are suitable for your particular
application, nor do we assume any responsibility for your product design, installation, or operation.
If you have any questions concerning the installation or operation of this equipment, or if you need additional
information, please call technical support at 1-800-633-0405 or 770-844-4200.
This publication is based on information that was available at the time it was printed. At Automationdirect.com
we constantly strive to improve our products and services, so we reserve the right to make changes to the
products and/or publications at any time without notice and without obligation. This publication may also discuss
features that may not be available in certain revisions of the product.
Proper grounding and wiring of all electrical equipment is important to help ensure the
optimum operation of the StrideLinx router and to provide additional electrical noise
protection for your application.
The StrideLinx router comes with a female 4-pin plug-in connector with screw connection
(type: Weidmuller BL 5.08/04/180 SN BK BX).
StrideLinx™ Cloud 2.0 Industrial VPN Routers User Manual 1st Edition Rev. C
®
1-9