Configure Carrier Setting; Figure 3-32: Quick Setting - Baicells Nova436Q Installation Manual

Nova436Q Outdoor 4x1W Two-Carrier TDD eNodeB Installation Guide

Figure 3-32: Quick Setting

3.8.7 Configure Carrier Setting

Reference: Carrier Aggregation and Dual Carrier/Split Mode Configuration Guide
The BTS Setting > Carrier Setting sub-menu (Figure 3-33) is used in eNBs running BaiBLQ software to enable
a desired carrier mode setting. You can set the eNB to run as a single carrier, as two combined carriers
using carrier aggregation, or as two independent carriers using dual carrier, depending on which licenses
you have purchased. Single carrier (no CA) means only Cell 1 will operate and use only two RF ports instead
of four. Operators may need to use this mode if they have limited spectrum or are planning to change to
CA or DC mode at a later time when more capacity is needed for the coverage area.
Go to BTS Setting > Carrier Setting to configure Carrier Mode. Click the arrow to view the drop-down menu.
NOTE: Whenever you change the carrier setting, you must reboot the eNB for the change to take
effect.
41