Table of Contents
Advertisement
1.
1.
The operator must be familiar with the contents of the OPERATION section
The operator must be familiar with the contents of the OPERATION section
before starting the roller.
before starting the roller.
2.
2.
Ensure that all instructions in the MAINTENANCE section are followed.
Ensure that all instructions in the MAINTENANCE section are followed.
3.
3.
Only the operator is allowed to be on the roller. Remain seated at all times
Only the operator is allowed to be on the roller. Remain seated at all times
when operating the roller.
when operating the roller.
4.
4.
Never use the roller if it is in need of adjustment or repair.
Never use the roller if it is in need of adjustment or repair.
5.
5.
Only ascend and descend the roller when it is stationary. Use the intended
Only ascend and descend the roller when it is stationary. Use the intended
footsteps, grips and rails. Always use the three-point grip (both feet and one
footsteps, grips and rails. Always use the three-point grip (both feet and one
hand, or one foot and both hands) when ascending or descending the
hand, or one foot and both hands) when ascending or descending the
machine. Never jump down from the machine.
machine. Never jump down from the machine.
6.
6.
The ROPS (Roll Over Protective Structure) shall be used.
The ROPS (Roll Over Protective Structure) shall be used.
7.
7.
Drive slowly in sharp bends.
Drive slowly in sharp bends.
8.
8.
Avoid driving across slopes. Drive straight up or straight down the slope.
Avoid driving across slopes. Drive straight up or straight down the slope.
9.
9.
Never operate with roller outside the edge, if the substrate does not have full
Never operate with roller outside the edge, if the substrate does not have full
bearing strength or is close to a slope. Avoid operating close to edges and
bearing strength or is close to a slope. Avoid operating close to edges and
ditches and the like as well as on poor ground conditions that influence the
ditches and the like as well as on poor ground conditions that influence the
bearing strength and capacity to support the roller.
bearing strength and capacity to support the roller.
10. Make sure that there are no obstacles in the direction of travel, on the
10. Make sure that there are no obstacles in the direction of travel, on the
ground, in front of or behind the roller, or overhead.
ground, in front of or behind the roller, or overhead.
11. Drive particularly carefully on uneven ground.
11. Drive particularly carefully on uneven ground.
12. Use the safety equipment provided. The seat belt must be worn on machines
12. Use the safety equipment provided. The seat belt must be worn on machines
fitted with ROPS/ROPS-cab.
fitted with ROPS/ROPS-cab.
13. Keep the roller clean. Clean any dirt or grease that accumulates on the
13. Keep the roller clean. Clean any dirt or grease that accumulates on the
operator platform immediately. Keep all signs and decals clean and legible.
operator platform immediately. Keep all signs and decals clean and legible.
14. Safety measures before refueling:
14. Safety measures before refueling:
- Stop the engine
- Stop the engine
- Do not smoke.
- Do not smoke.
- No naked flames in the vicinity of the roller.
- No naked flames in the vicinity of the roller.
- Earth the filling equipment nozzle to the tank opening to avoid sparks.
- Earth the filling equipment nozzle to the tank opening to avoid sparks.
15. Before repairs or service:
15. Before repairs or service:
- Chock the drums/wheels.
- Chock the drums/wheels.
- Lock the articulation if necessary.
- Lock the articulation if necessary.
- Place blocks under overhanging equipment, such as strike-off blade and
- Place blocks under overhanging equipment, such as strike-off blade and
chip spreader.
chip spreader.
2019-04-30
Safety - General instructions
Safety - General instructions
(Also read the safety manual)
4812163801.pdf
5
Advertisement
Table of Contents
