Driving; Operating The Roller; Machine With Gear Change In Separate Spring-Return Switch (Gear Position Switch) - Fayat Group DYNAPAC CA4600 Instruction Manual

1
2
Fig. Control panel
1. Speed selector
2. Parking brake
3. Forward/Reverse lever
1
Fig. Control panel
1. Gear position switch
2. Forward/Reverse lever
74

Driving

Operating the roller

3
Activate working speed (1) = HI or ECO if available.
In ECO, the machine automatically regulates the
engine speed according to requirements.
If the machine is only to be transported, MID or ECO
should be selected instead.
Check that the steering is working correctly by turning
the steering wheel once to the right and once to the
left while the roller is stationary.
Machine with gear change in separate
spring-return switch (gear position switch)
Switch (1) is a spring-return gear position switch,
2
where gear change is performed by advancing through
the four different gear positions: Hare, Drum spin,
Wheelspin and Tortoise.
4812163801.pdf
Under no circumstances is the machine to be Under no circumstances is the machine to be
operated from the ground. The operator must be operated from the ground. The operator must be
seated inside the machine during all operation. seated inside the machine during all operation.
Make sure that the area in front of and behind the Make sure that the area in front of and behind the
roller is clear. roller is clear.
Release the parking brake (2). Release the parking brake (2).
Operation
2019-04-30