Table of Contents
Advertisement
5
3
4
5
1
2
Fig. Engine compartment
1. Water cooler
2. Charge air cooler
3. Hydraulic fluid cooler
4. Condenser element AC (Optional)
5. Screws (x 2)
2
Fig. Drum, drive side
1. Rubber element
2. Attachment screws
128
Radiator - Check/Cleaning
Check that air can pass unobstructed through the
radiators (1), (2) and (3).
Clean a dirty radiator using compressed air or a
high-pressure water jet.
Undo the two screws (5) and tilt the condenser
element upwards.
Blow air or direct water through the cooler in the
opposite direction to that of the cooling air.
Rubber elements and fastening screws - Check
Check all rubber elements (1), replace all of the
elements if more than 25% of them on one side of the
drum are cracked deeper than 10-15 mm (0.4-0.6 in).
Check using a knife blade or pointed object.
Check also that the screw fasteners (2) are tightened.
1
4812163801.pdf
Maintenance measures - 250 h
Be careful when using a high-pressure washer -
Be careful when using a high-pressure washer -
do not place the nozzle too close to the radiator.
do not place the nozzle too close to the radiator.
Wear protective goggles when working with
Wear protective goggles when working with
compressed air or high-pressure water jets.
compressed air or high-pressure water jets.
2019-04-30
Advertisement
Table of Contents
