Remote Control; Installing The Batteries - Strong SRT 3001 User Manual

Digital high definition cable receiver
Table of Contents

Advertisement

3. S/PDIF COAX.
4. HDMI
5. TV SCART
6. Power cord

2.4 Remote Control

1. q
2. !
3. PG+/PG-
4. DTV/VCR
5. INFO
6. VOL+/VOL-
7. MENU
8. EXIT
9. pq
10. t u
11. OK
12. RECORD
13. TIMESHIFT
14. 0~9
15. EPG
16. RECALL
17. AUDIO
18. TV/RADIO
19. FAV
20. FILE
21. TTX
22. SUBTITLE
23. 5 6
24. Coloured buttons
* This user manual describes the full functionality including the recording function and may not be applicable if the software for recording via
USB has not yet been installed.

2.5 Installing the batteries

Open the cover on the remote control and insert 2x AAA batteries into the compartment. Correct position of the polar
diagram shows the batteries inside the compartment.
1. Open the cover.
2. Insert the batteries.
3. Close the lid.
WARNING:
The batteries should not be recharged, disassembled, electrically short-circuited, be mixed or
used with other types of batteries.
Connect your receiver to a digital home theatre, AV receiver or digital audio
amplifier.
Connect your receiver with your TV set using an HDMI cable.
Connect your receiver with your TV set using a SCART cable.
Your receiver requires a supply voltage of 220~240V AC (Auto-selectable), 50/60Hz
+/-5%. Please ensure the local power specification meets these requirements
before connecting your receiver to the wall outlet.
Switches the receiver On/Standby
Mutes all audio outputs of the receiver
Page up/down in all list modes
No function
Opens the current channel information; 2x opens the current event information
and 3x the signal information
Increases/decreases the volume level
Opens the main menu, in a menu you will get one step back
Exits from the menu or sub-menu
Menu Off: Change channel to next/previous.
Menu On: Moves the cursor up/down.
Menu Off: Decreases/ increases the volume level.
Menu On: Change settings for specific menus
Menu Off: Displays the current channel list
Menu On: Activates the highlighted menu item.
Records the TV programme to the connected USB storage device*
Activates the Timeshift function (Off/On) *
Enters a channel number in viewing mode or a value inside the respective menu
Opens the EPG (Electronic Programme Guide) in TV mode
Back to previously watched channel
Opens the audio language selection
Toggles between TV or RADIO mode
Opens the favourite group selection
Opens the Media Player list
Displays Teletext on the OSD (On Screen Display)
Shows a list of subtitle languages
Fast rewind/fast forward
For Multimedia and Teletext functions
Fig. 3
Fig. 4
5

Advertisement

Table of Contents
loading

Table of Contents