Installing The Batteries; Using The Remote Control - Strong SRT 8541FTA User Manual

Digital terrestrial receiver
Table of Contents

Advertisement

13. OK
14. MENU
15. 
16. VOL+/VOL-
17. P+/P-
18. LIST
19. CH+/CH-
20. OPT
21. TEXT
22. SUB
23. 
24. 2
25. 5 6
26. 4
27. u
28. 78
29. 3
30. COLOUR BUTTONS
* Subtitles, Videotext, EPG (Electronic Programme Guide), and Audio languages are depending on availability in the
specific broadcast

2.5 Installing the batteries

Open the cover on the remote control and insert 2x AAA type batteries into the compartment.
Observe correct polarity of the batteries when inserting. A terminal diagram is shown inside the
compartment.
1. Remove the cover.
2. Insert the batteries.
3. Place the cover.

2.6 Using the remote control

To use the remote control, point it towards the front of your receiver. The remote control supports a
range of up to 5 meters distance to the receiver at an angle of up to approx. 30 degrees.
NOTE:
6
Opens the current channel list in menu: for confirmation
Opens the main menu, in a menu you will get one step back.
Exits from the menu or sub-menu.
Increases/decreases the volume level.
Page up/down in all list modes.
Call the current channel list.
Channel up/down.
Opens quick menu to adjust screen settings
Opens the Teletext* if available
Shows a list of subtitle* languages.
No function
Hold play during playback/starting Timeshift mode
Fast rewind/fast forward.
Starts recording of the currently watched programme
Opens the multimedia menu
Jump function in multimedia playback
Stop playback.
In different menus for specific functions
Managing the receiver will be limited or not possible if there are obstacles
between the remote control sensor (at the front panel of the receiver)
and the remote control. Direct sunlight or very bright light can reduce or
disturb the reception of the remote control signals.
Fig. 4
Fig. 5

Advertisement

Table of Contents
loading

Table of Contents