Table of Contents
Advertisement
Problem Detected and MIN LED
When these lights illuminate together, the cell reports salt levels below 1500.
Verify Moving Water Fully Covers Cell Plates
Remove Power From the AQR100
Step 3D
Step 3C
Turn power off for 2
mins, then back on
Inspect cell vessel, verify cell plates are fully coveredby
Remove power to the AQR100 for two minutes.
moving water. If NOT fully covered by moving water,
Re-apply power to reset the system. If error does not
clear obstructions. If error persists, go to step 3D.
clear replace the cell (CCELL).
38
Advertisement
Table of Contents
