Table of Contents
Advertisement
No LED's On Display (Cont.)
No LED's indicate a loss of power to/within the AQR100
Re-assemble AQR100
Replace PCB
Step 1M
Step 1L
Verify all cables and plugs are properly connected.
If all else is correct replace the PCB (GLXAQR100PCB).
Check that the display ribbon cable is attached as shown.
*Remove all plugs from PCB. Remove the 5 screws that
Place cover back onto the AQR100 and reinstall the 10
hold PCB to the AQR100. Remove and replace PCB.
Phillips head screws to secure the frontcover.
Reattach all plugs and cables and restore power.
29
Advertisement
Table of Contents
