Table of Contents
Advertisement
Chapter 2 Preparations
Installing secondary riser card options
If you intend to mount a three-quarter length GPU option, you should install a low-profile Type-a (AROC) RAID
Controller.
Please check if the capacity of power unit is enough before installing this option.
Please prepare the following before installing the option.
Parts included in the option kit
T-10 hexalobular driver
To install the components, follow these steps.
1.
Back up all data in the server.
2.
See steps 1 to 6 in Chapter 2 (1.2 Overview of Installation and Removal) for preparations.
3.
If the secondary riser card is mounted, remove it.
94
Important
The surface becomes hot after use so to avoid burns please allow the drive
and internal parts of the system to cool before touching.
Note
In order to prevent the damage to electronic components, please start to install the
system after conducting the appropriate anti-static treatment. There is a possibility
of causing electrostatic discharge if appropriate grounding wire treatment is not
conducted.
Express5800/R120h-1M User's Guide
1. Installing Internal Optional Devices
Advertisement
Table of Contents
