Table of Contents
Advertisement
Chapter 2 Preparations
4.
Insert the optical disk drive from the front and then fix it with a screw.
5.
Connect the SATA cable (K410 - 375 (00)) for the optical disk drive to the built and the on board SATA port
5 connector as shown below.
6.
See Chapter 2 (1.26 Installing Top Cover) to attach the top cover of the server.
7.
Please see Chapter 2 (2 Installation and Connection) in this manual to conduct installation and connection,
and turn the power supply ON.
Removal
The procedure for removal is the reverse of installation.
Re-attach the blank cover if you operate without it attached.
138
Note
In order to prevent damage of the system due to improper cooling or elevated
temperature, please do not activate the server or enclosure without implementing
any of component or blank on all of drive bays and device bays.
Important
Re-attach the blank cover removed to maintain the internal cooling.
Express5800/R120h-1M User's Guide
1. Installing Internal Optional Devices
Advertisement
Table of Contents
