Installing Pci Board In The Primary And Secondary Riser Cage - NEC Express5800 Series User Manual

Chapter 2 Preparations
1.10.3

Installing PCI board in the primary and secondary riser cage

Please prepare the following before installing the option.

Parts included in the option kit

T-10 hexalobular drive
To install the components, follow these steps
1. Back up all data in the server.
2. See steps 1 to 6 in Chapter 2 (1.2 Overview of Installation and Removal) for preparations
3. See Chapter 2 (1.9 Riser Card) to remove the riser card.
4. See supported PCI boards and mountable slots and confirm the installation location.
5. Remove the blank cover of the riser card.
Important When installing a PCI card, make sure the connector of the card fits the
connector of the riser card.
Note
Check the card type (Low profile or Full Height) which respective riser card supports
and the type of PCI card to be installed.
Important
To reduce the risk of personal injury, electric shock, or damage to the
equipment, remove the power cord to remove power from the server. The
front panel Power On/Standby button does not completely shut off system
power. Portions of the power supply and some internal circuitry remain
active until AC/DC power is removed.
Note
For proper cooling, do not operate the server without the access panel, baffles,
expansion slot blanks, or blanks installed. If the server supports hot-plug
components, minimize the amount of time the access panel is open.
Important
The surface becomes hot after use so to avoid burns please allow the drive
and internal parts of the system to cool before touching.
Note
In order to prevent the damage to electronic components, please start to install the
system after conducting the appropriate anti-static treatment. There is a possibility
of causing electrostatic discharge if appropriate grounding wire treatment is not
conducted.
Express5800/R120h-1E User's Guide
1. Installing Internal Optional Devices
89