Table of Contents
Advertisement
Chapter 2 Preparations
Installation
Follow the steps below to install a DIMM.
See steps 1 to 6 in Chapter 2 (1.2 Overview of Installation and Removal) for preparations.
Open levers on left and right sides of DIMM slot.
Push the DIMM straight into the slot.
When a DIMM is inserted into the slot, the lever automatically closes.
Notch
Continue to install/remove the internal options.
Refer to Chapter 2 (1.26 Installing Top Cover) in this manual to replace the top cover.
Refer to Chapter 2 (2 Installation and Connection) in this manual to install/connect and turn the
power ON.
Confirm that no error messages are displayed in POST screen.
Using RBSU in System Utility, configure the memory mode.
Regarding the trouble shooting on a malfunctioning DIMM or the information on LEDs, see (4) Status
LED Panel combined LED descriptions.
Important
Make sure the orientation of the DIMM. The DIMM has a notch, preventing
being incorrectly inserted.
Do not apply too much pressure when you push a DIMM into the slot.
Doing so can damage the socket or terminal part.
Note
In order to prevent damage of the system due to improper cooling or elevated
temperature, please do not activate the server or enclosure without implementing
any of component or blank on all of drive bays and device bays.
Express5800/R120h-1M User's Guide
1. Installing Internal Optional Devices
75
Advertisement
Table of Contents
