Table of Contents
Advertisement
Chapter 2 Preparations
Installing primary riser card (SATA M.2) N8116-53
Please prepare the following before installing the option.
Parts included in the option kit
M.2 media (If expanding)
Phillips screwdriver
To install the components, follow these steps.
1.
See steps 1 to 6 in Chapter 2 (1.2 Overview of Installation and Removal) for preparations.
2.
Pick up the both end part of the primary riser card and lift them up to remove.
3.
Take off the screws fixed on the stand off of riser card.
Note
In order to prevent the damage to electronic components, please start to install the
system after conducting the appropriate anti-static treatment. There is a possibility
of causing electrostatic discharge if appropriate grounding wire treatment is not
conducted.
Express5800/R120h-1M User's Guide
1. Installing Internal Optional Devices
85
Advertisement
Table of Contents
