Chapter 2 Preparations
11. Attach the rear drive riser card to the position of the primary riser card. Align the terminal part of the riser
card with the slot part on the motherboard, and insert them securely.
12. Connect the data cable and the power cord as shown below.
13. See Chapter 2 (1.26 Installing Top Cover) to attach the top cover of the server.
14. Install the driver or the dummy tray.
15. Please see Chapter 2 (2 Installation and Connection) in this manual to conduct installation and connection,
and turn the power supply ON.
Removal
The procedure for removal is the reverse of installation.
Re-attach the blank cover if you operate without it attached.
142
Rear drive riser card
Note
In order to prevent damage of the system due to improper cooling or elevated
temperature, please do not activate the server or enclosure without implementing
any of component or blank on all of drive bays and device bays.
Important
Re-attach the blank cover removed to maintain the internal cooling.
Express5800/R120h-1M User's Guide
1. Installing Internal Optional Devices