Table of Contents
Advertisement
Chapter 2 Preparations
1.11.5
Removal
Remove a PCI card connected to a PCI slot by using the following procedure.
1.
See steps 1 to 3 in Chapter 2 (1.3 Overview of Installation and Removal) for preparations.
2.
To remove the side cover, see Chapter 2 (1.4 Removing the Side Cover).
3.
See installation steps 4 and 5 in Chapter 2 (1.11.3 Installation) to close the PCI retention latch.
4.
Remove the card.
5.
Attach the blank cover, and see installation step 8 in Chapter 2 (1.11.3 Installation) to close the PCI
retention latch.
6.
Assemble the server.
7.
Turn on the server and confirm that no error messages are displayed in POST.
If an error message is displayed, take notes on the message and ask your sales representative.
1.11.6
Installing the N8117-01A extra RS-232C connector kit
Install a PCI card to connect to the PCI slot by using the following procedure. For details, refer to the
instruction manual supplied with the connector kit.
The component parts for N8117-01A are as follows:
Item no.
RS-232C connector Kit
<1>
User's Guide
<2>
RS-232C cable (A)
<3>
RS-232C cable (B)
<4>
PCI bracket (1)
<5>
PCI bracket (2)
<4>
This product uses a combination of items <3> and <5>.
Follow the procedure below to install the kit.
1.
See Chapter 2 (1.3 Overview of Installation and Removal) for preparations.
2.
To remove the side cover, see Chapter 2 (1.4 Removing the Side Cover).
3.
Assemble <3> RS-232C cable (B) and <5> PCI bracket (2).
74
Item name
Specification
856-125671-002
804-063264-020
804-062746-820
243-112122-001
243-112122-002
<2>
Express5800/T110g-E User's Guide
1. Installing Internal Optional Devices
Amount
Remark
1
1
Not available for this server
1
1
Preinstalled to cable
1
For full height PCI
<5>
<3>
Advertisement
Table of Contents
