Performing The Tests - Viavi FCOMP/-PRO T-BERD/MTS-2000V2 User Manual

NOTE
Some configuration files are available in the Platform: press F
disk > config > FCOMP.

Performing the tests

Below are described the steps when Loopback OTDR measurement has been selected
and inspection of the connectors has been validated.
1 Connect a loopback cable
each fiber end
2 Connect a launch cable
- 1st fiber and a
Origin - 2nd fiber
3 Connect the launch cable
Module.
4 Launch the measurement from
Launch cable toward
cable
Once completed, a pop up mes-
sage displays on the Platform:
5 Follow the instructions displayed:
connect the receive cable
Module of the Platform.
6 Press Start lo launch the
measurement from
cable toward Launch cable
Once measurement is completed, the results display.
at
at Origin
receive cable at
to the
Receive
to the
Receive
User Manual 700MAN203 Rev. 007
Chapter 5 Loopback OTDR
Performing the tests
and select
ILE
59