Table of Contents
Advertisement
Chapter 6 TrueBIDIR OTDR
Adding an event (in OTDR Expert mode only)
Figure 49
OTDR results
1 & 2: 1310/15550 nm A -> B
NOTE
By clicking on the upper tabs SmartLink and Table you have access to addi-
tional representation of results, but for the selected direction only. The direc-
tion can only be changed via the Trace view.
Adding an event (in OTDR Expert mode only)
If there are known events which have not been displayed those can be marked on
(added) to the OTDR trace or link map to provide a 100% complete, real world view of
a fiber link.
CAUTION
This procedure cannot be done if Cable View is set in FiberComplete PRO.
Please make sure Fiber view is selected.
NOTE
The OTDR traces visible in the Expert OTDR tab correspond to the latest
done/measured. To edit previous measurements, go to the file explorer and
re-load the desired ones. Make sure the .fcpro results match as well.
74
User Manual
3 & 4: 1310/15550 nm B -> A
700MAN203 Rev. 007
Advertisement
Table of Contents
