Table of Contents
Advertisement
Chapter 5 Loopback OTDR
Configuring the Loopback Test
Figure 39
Save Configuration file - Edition keypad
Directory into which
file will be saved
NOTE
Configuration file is saved by default in the directory disk / config / FCOMP.
3
Press
The configuration file is saved with the extension «fo_cfg» (icon
NOTE
The configuration file includes data storage and measurement settings of
Loopback and Expert OTDR. This configuration file can be shared and reused
with other units.
Loading a configuration file
The configuration file includes OTDR and FCOMP setup and file parameters.
To load a configuration file previously created and apply parameters to new tests:
1
Press L
2
Select the configuration file in the wished directory.
3
Press
•
Press S
in the configuration file.
You can modify some acquisition or file storage parameters, and save them in a new
configuration file (see
58
to validate
C
OAD
ONFIGURATION
Load Config.
key to display the OTDR and FCOMP acquisition parameters saved
ETUP
"Saving configuration" on page
User Manual
key
700MAN203 Rev. 007
.
57).
).
Advertisement
Table of Contents
