Channel Search; Time - Strong SRT 8209 User Manual

16:9 Pillarbox
16:9 Pan&Scan
16:9 Pillarbox 16:9 Pan&Scan
Resolution
576i:
576p:
720p:
1080i:
1080p(50Hz):
Auto:
TV Format

7.5 Channel Search

Auto Search
Manual Search
Country
Antenna Power
Scan Mode

7.6 Time

Set up your time zone for clock/time in your menu and system.
Time Offset
14
A 4:3 programme will be shown normally, but with black bars to the left and
right.
A 4:3 programme will be shown as a centre blow up to fill the whole screen,
missing content to the left, right, top and bottom of the programme.
broadcasts in full screen on a 4:3 TV. Letterbox: black bars on top and bottom
of the picture on a 4:3 TV. Combined: shows a mix in-between. Ignore: shows
as it is.
If the video quality does not appear correctly, change the setting. These
settings match the most common settings for HDMI.
For analogue TVs (on Scart connection).
For digital SD TVs (some digital TVs do not support this mode).
For digital HD TVs (on HDMI connection).
For digital HD TVs (on HDMI connection).
For digital HD TVs (on HDMI connection).
The best possible resolution available will be auto negotiated by between
TV and receiver ('handshake') when using a modern digital HD TV when
connected with an HDMI cable.
Options are PAL and NTSC. For European broadcasts, the TV format is PAL
(Default). The setting is most important for TVs connected via Scart cable.
Using NTSC might deliver black& white pictures.
This menu allows you to search for channels from all available frequencies
for your selected region automatically. Be aware that all previous installed
channels and favourite list(s) will be deleted. The new-found channels will be
installed in the channel list and afterwards you can create a new favourite list
if you like. Press OK to start the scan.
Select a particular channel to do a search on just one (known) frequency.
Press OK to start the scan. The signal quality bar might
check if the frequency is indeed in use.
Select the correct country where this receiver is used. If failing to do so, may
result in that channels appear randomly in the channel list, instead of a more
logical order.
Set to On if you use an active antenna. When set to On, 5 V will be present at
the RF in connector of the receiver. Select Off for passive antennas.
Select between FTA (Free-To-Air), which will only install Free-to-Air channels
or All, which will install all found channels, even if they are scrambled. Then
select Auto Search or Manual Search and press OK to start scanning.
The GMT time can automatically be determined from the incoming TV
broadcast if set to Auto. The time zone is determined from the Country
setting in the Channel Search menu. If set to Manual, you can change the
Time zone yourself in the Time Zone option. Default is Auto.
be useful to