Strong SRT 8221 User Manual page 21

LNB Power
22 KHz
DiSEqC1.0/1.1
Motor
DiSEqC 1.2
DiSEqC 1.2 is a protocol for motor-driven dishes, the dish/motor-combination itself needs to be
aligned due South (North for Southern hemisphere) at its reference position at 0°. It is possible to
manually search and store every satellite individually.
Refer to the manual of your motor-drive for more detailed information. Modern motor drives have
usually also the capability of the enhanced DiSEqC 1.3 protocol, which would be preferred, since it
can find satellite positions automatically, relative to a geographical location.
Move the motor to the right position for locking the signal like explained below.
Use t u to select DiSEqC 1.2, then press OK to enter the submenu.
Move Auto:
Move Continue:
Move Step(1):
Store Position:
Goto Position:
Goto Reference:
NOTE:
DiSEqC 1.3
DiSEqC 1.3 (also known as GotoX) is an automated system for finding satellites with a motor driven
dish. It is an enhancement of the DiSEqC 1.2 protocol, where it was still needed to manually search
and store every satellite individually. With DiSEqC 1.3 every satellite position is automatically
calculated for a defined geographical location on earth. Only this location is needed to be entered
and stored in to the box, in conjunction with a DiSEqC 1.3 capable motor drive, all (pre-installed)
satellites can easily be found. The dish/motor-combination itself needs to be aligned due South
(North for Southern hemisphere) at its reference position at 0°. Refer to the manual of your motor-
drive for more detailed information.
Select DiSEqC 1.3 with the t u buttons. Press the GREEN button to setup your location coordinates.
A pop-up window will appear, in which the following settings can be made:
Location:
Other options:
Use pq to select the LNB power and t u to modify the setting. 13/18V is
the setting for a Universal LNB.
Use t u to switch the 22KHz oscillator signal on or off. Auto is the setting for
a Universal LNB.
DiSEqC1.0 to select the correct port from up to 4 (if available) for the
corresponding LNB. DiSEqC1.1 to select the correct port from up to 16 (if
available) for the corresponding LNB.
If using a motor driven dish, press t u to choose between DiSEqC1.2 and
DiSEqC 1.3 depending on the motor type you use.
Press t u for moving West/East. Press the opposite t u to stop moving.
Press t u for moving West/East. Press the opposite t u to stop moving.
Press t u for moving West/East in 0.3° step.
To store the current motor position for selected satellite. Press u and OK to
confirm.
To move the dish to the last position stored. Press u and OK to confirm.
To move the dish to the 0.0° position. Press u and OK to confirm.
In the case that your Satellite Dish is obstructed in the movement towards
West or East, see the chapter Set limit here below.
Use t u to select Manual to set your own position by using the below
instruction. This option contain also a list of cities with preset coordinates.
Longitude Direction: Choose East or West.
Longitude Angle: Use the 0 ~ 9 buttons to enter the coordinate.
17