Time - Strong SRT 8221 User Manual

Other options
At the bottom of the screen there are some commands (color buttons) to make changes to satellites
or transponders (use INFO button to choose between Satellite and Transponder
Add
Edit
Delete
Scan
7.3.2 Terrestrial Channel Search
To access the terrestrial channel search press MENU and use t u to select Channel Search. Then use
pq to select Terrestrial Channel Search and press OK. To access this menu it is necessary to insert the
PIN code set during the first installation.
Auto Search
Manual Search
Country
Antenna Power

7.4 Time

Set up your time zone for clock/time in your menu and system.
Time Offset
Time Zone
Sleep
Power On/Off
Power On
Power On Time
Power Off
Press RED button to add a new Satellite/Transponder.
Press GREEN button to modify the value of the Satellite/Transponder.
Press YELLOW button to delete one Satellite/Transponder.
Press BLUE button to start the scan.
This menu allows you to search for channels from all available frequencies
for your selected region automatically. Be aware that all previous installed
channels and favourite list(s) will be deleted. The new-found channels will be
installed in the channel list and afterwards you can create a new favourite list
if you like. Press OK to access the menu, with t u select Yes to start the scan
or No to back in view mode without scan.
Select a particular channel to do a search on just one (known) frequency.
Press OK to access the sub-menu and use t u to select the channel to be
scanned, then press OK to start the scan. The signal quality bar might be
useful to check if the frequency is indeed in use.
Select the correct country where this receiver is used. If failing to do so, may
result in that channels appear randomly in the channel list, instead of a more
logical order.
Set to On if you use an active antenna. When set to On, 5 V will be present at
the RF in connector of the receiver. Select Off for passive antennas.
The GMT time can automatically be determined from the incoming TV
broadcast if set to Auto. The time zone is determined from the Country
setting in the Channel Search menu. If set to Manual, you can change the
Time zone yourself in the Time Zone option. Default is Auto.
If the correct time cannot be obtained from the incoming TV broadcast,
change the Time Zone setting yourself.
Example: in case of Daylight Saving Time.
As a power saving feature, the unit will switch to Standby automatically, if no
command from the remote control is received for the set time. Options are 1
Hour up to 12 Hour and Off. Default is 3 hours.
You can set a time to automatically switch On and/or Off the unit every day.
The unit will start on the last watched channel.
Note: Set Auto Standby function to Off.
Set to Enable if you want to use the automatically switch On function.
Enter the switch On time with the numeric buttons on the remote control.
Set to Enable if you want to use the automatically switch Off function.
19