Abilica Mill 30 Manual page 79

BELT ADJUSTMENT
Place treadmill on a level surface. Make treadmill run at approximately 6-8 km/h,
observe the running belt deviate condition.
If the belt has drifted to the right, unplug the safety lock and power switch, and turn
the right adjusting bolt 1/4 turn clockwise, then insert the power switch and safety
lock, make the treadmill running, observe the running belt deviate condition.
Repeat above steps until the running belt be placed in the middle.
Once the treadmill belt swerving to the left, unplug the safety lock, turn off the power,
then with the left adjusting bolt clockwise rotation 1 / 4 laps, and turn on the safety
lock and power to make treadmill running, checking the deviation of the treadmill
belt. Repeat the above
Steps until belt is centered.
The treadmill belt will gradually relax after above steps or after a period of time using,
unplug the safety lock, and turn off the power, with the two adjusting bolt clockwise
rotation 1 / 4 laps, and turn on the safety lock and power to make treadmill running,
then standing on the belt to confirm the tightness.
Repeat the above steps until the belt moderate tightness.
79