Abilica Mill 30 Manual page 64

1.12 User Programs
There are 3 user-defined programs: U1, U2, and U3. Each user program has 10
segments. You can set the desired speed and incline for each segment.
1.12.1 Press "PROGRAM" button to choose U1, U2, or U3 program, and then press
"MODE" button to enter into setting.
1.12.2 After entering the program, the number behinds U1, U2 and U3 presents which
segments you're setting now. For example, the first segment of U1 shows "U1-01" and
last segment of U1 shows "U1-10".
1.12.3 Rotate the SPEED QUICK WHEEL or INCLINE QUICK WHEEL button to set training
time of the first segment.
1.12.4 Press "MODE" button to begin the setting of the next segment. The console
display flashes and go through the same procedure in previous step to complete the
setting for all the following segments.
1.12.5 You must complete the setting for all 10 segments in order to have your user
program to begin.
1.12.6 Press "STOP" button to return to previous segment at any time to revise training
setting.
1.12.7 Default setting value under user program:
(1) User 1: default speed is 1 km/h
(2) User 2: default speed is 2 km/h
(3) User 3: default speed is 3 km/h
64