Abilica Mill 30 Manual page 73

1.16 ERROR CODE
Error Code Problems
E01 Connection fails
between "PCB" and
"Lower Control Board"
E02 Over-loading Protection
E03 Speed Sensor Error
E05 Over-current Protection
E06 Controller Error from Self
Examination
Solutions
6. Check every wire is connected well
between PCB and lower control
board.
7. Check if any of the wire is damaged.
8. Check if PCB or lower control board is
in good condition. If any chip is
damaged, change PCB or lower
control board.
7. Check if power outlet has low voltage
supply. If so, change a different
power outlet.
8. Check if lower control board has bad
smell. If so, change a lower control
board.
9. Check if wires connected to motor
are well connected.
5. Check the speed sensor is well
connected or not.
6. Replace the speed sensor.
9. Check if any part on motor is stuck.
Un-plug power cable and adjust or
change a motor. Plug back in the
power cable and re-start to run the
treadmill.
10. Check if motor has burned smell. If so,
change a motor.
11. Check if lower control board has
burned smell. If so, change a lower
control board.
12. Check if power outlet has low voltage
supply. If so, change a different
power outlet.
4. Try to start the treadmill to check if
motor runs. If not, check the wires of
motor are well connected.
5. Check if the protector tube of lower
control board is loosened or
damaged. If so, re-plug the wire or
change a new one.
73