Pitney Bowes DP40S Operator's Manual page 43

Paper
Stoppages
SV62531 Rev. B
4. If paper is stuck in the fuser unit, push
the lock lever in the direction shown to
release the unit.
Be careful not to touch the fuser unit which may be hot after printing. If the
fuser unit is hot, wait until it cools before attempting to remove any stuck
paper. Holding the fuser unit by the handle, lift it out of the printer and place
it on a flat surface.
5. Pull up the stoppage release levers
and remove the stuck paper.
6. Carefully refit the fuser unit into the
printer and turn the lock lever to
complete the fuser install.
7. If paper is stuck near the paper exit,
slide the Conveyor away from the
printer.
8. Open the printer top cover and release
the fuser pressure latches.
9. Move the conveyor away from the
printer.
10. Open the side cover (paper exit) and
remove the stuck paper.
11. Close the side cover (paper exit).
12. Return the image drum basket into
position and check that it is locked.
13. Close the top cover and ensure it is
latched.
14. Relocate the conveyor.
4 • Troubleshooting
4-3