Dalsa Linea Lite GigE Series User Manual page 82

Trigger Delay
Rotary Encoder Output
Mode
Position
Motion
Rotary Encoder Direction
Clockwise
Counter Clockwise
Rotary Encoder Input A
Source
Line 1
Line 3
Rotary Encoder Input B
Source
GND
Line 2
Rotary Encoder Source
Activation
Rising Edge
Any Edge
Rotary Encoder Rescaler
Order
Multiplier Divider
Divider Multiplier
Rotary Encoder Multiplier
Rotary Encoder Divider
Rotary Encoder Position
Input A ahead B
Input B ahead A
80 • Operational Reference
TriggerDelay
rotaryEncoderOutputMode
Position
Motion
rotaryEncoderDirection
Clockwise
CounterClockwise
rotaryEncoderInputASource
Line1
Line3
rotaryEncoderInputBSource
GND
Line2
rotaryEncoderSrcActivation
RisingEdge
AnyEdge
rotaryEncoderRescalerOrder
multiplierDivider
dividerMultiplier
rotaryEncoderMultiplier
rotaryEncoderDivider
rotaryEncoderPosition
SrcA
SrcB
Specifies the delay to apply after receiving the trigger and
before activating triggerEvent. The delay can be set in
m icroseconds.
Specifies the conditions for the Rotary Encoder interface to
generate a valid Encoder output signal.
On the camera, the "position" behaviour exists, but the
number of counts is small (7-bits / 128 counts). The
encoder can reverse for 256 ticks and then go forward and
behave as expected for "position" style behaviour. If the
user exceeds 256 ticks, the count will max out, but will not
reset. When the user starts going forward again, 256 lines
will be dropped / ignored and then resume output.
The triggers are generated for all motion increments in
either direction.
Specifies the phase which defines the encoder forward
direction.
Inspection goes forward when the rotary encoder direction
is clockwise (phase B is ahead of phase A).
Inspection goes forward when the rotary encoder direction
is counter clockwise (phase A is ahead of phase B).
Selects which input line to assign to the rotary encoder
input A (also known as shaft encoder). Note that the Line
Mode feature m ust be set to Input. The list of supported
input line sources is device-specific.
Line 1 is assigned to the Rotary Encoder Input A.
Line 3 is assigned to the Rotary Encoder Input A.
Selects which input line to assign to the rotary encoder
input B (also known as shaft encoder). Note that the Line
Mode feature m ust be set to Input. The list of supported
input line sources is device-specific.
Rotary Encoder Input B is not used
Line 2 is assigned to the Rotary Encoder Input B
Specifies the signal edge(s) use to increment the rotary
encoder.
The rotary encoder uses the rising edge of the source
signal.
The rotary encoder uses either the rising edge or falling
edge of the source signal.
Specifies the order that the multiplier and divider are
applied.
The signal is multiplied before been divided.
The signal is divided before been multiplied.
Specifies a m ultiplication factor for the rotary encoder
output pulse generator.
Specifies a division factor for the rotary encoder output
pulse generator.
Displays the relative positions of rotary encoder inputs A
and B.
Linea Lite GigE Series Camera
Input A is ahead of Input B.
Input B is ahead of Input A.
Beginner
Expert
DFNC
Expert
DFNC
Expert
DFNC
Expert
DFNC
Expert
DFNC
Guru
DFNC
Beginner
DFNC
Beginner
DFNC
Guru
DFNC