Dalsa Linea Lite GigE Series User Manual page 74

Device User ID
Device Built-In Self Test
Device Built-In Self Test
Status
Passed
Firmware update failed
Sensor Initialization
Failure
Firmware Error
Unexpected Error
Device Built-In Self Test
Status All
Device Reset
Device Temperature
Selector
Internal
MaxInternal
Device Temperature
DALSA Software
Com patibility
Com ponent List
TurboDrive 8-bit
requires v8.01
or greater
TurboDrive 10-bit
requires v8.10 or
greater
TurboDrive 12-bit
requires v8.10 or
greater
Multicast requires a
newer version
Power-up Configuration
Selector
None
Factory Setting
UserSet1
UserSet2
UserSet3
UserSet4
72 • Operational Reference
DeviceUserID
deviceBIST
deviceBISTStatus
FirmwareUpdateFailure
FirmwareError
Unexpected_Error
deviceBISTStatusAll
DeviceReset
DeviceTemperatureSelector
DeviceTemperature
DALSASoftwareCompatibilityComponentList
Compatibility1
Compatibility2
Compatibility3
Compatibility4
UserSetDefault
Feature to store a user-programmable identifier of
up to 15 characters. The default factory setting is
the camera serial number. (RW)
Com mand to perform an internal test which will
determine the device status. (W)
Return the status of the device Built-In Self
Test.(BIST). Possible return values are device-
specific.
Passed No failure detected
Last firmware update operation failed.
There was an error initializing the sensor; the
SensorFailure
camera may not be able to capture images.
Firmware encountered an error during streaming.
Switched to recovery mode due to unexpected
software error.
Return the status of the device Built-In Self Test
(BIST) as a bit field. The m eaning for each bit is
device-specific.
Resets the device to its power up state. (W)
Select the source where the temperature is read.
Internal Read FPGA and / or PHY temperature.
MaxInternal Records the highest device temperature since
power up. Value is reset on power off.
The temperature of the selected source in degrees
Celsius
List the optional Teledyne DALSA software functions
that are supported.
Teledyne DALSA Turbo Drive 8-bit (Monochrome or
Bayer) requires Sapera-LT 8.01 or greater.
Teledyne DALSA Turbo Drive 10-bit (Monochrome
or Bayer) requires Sapera-LT 8.10 or greater.
Teledyne DALSA Turbo Drive 12-bit (Monochrome
or Bayer) requires Sapera-LT 8.10 or greater.
Multicast feature support requires a newer version
of Sapera LT than currently installed.
Selects the camera configuration set to load and
m ake active on camera power-up or reset. The
cam era configuration sets are stored in camera
non-volatile m emory. (RW)
None Keep Internal configuration.
Default Load factory default feature settings.
Select the user defined configuration UserSet 1 as
UserSet1
the Power-up Configuration.
Select the user defined configuration UserSet 2 as
UserSet2
the Power-up Configuration.
Select the user defined configuration UserSet 3 as
UserSet3
the Power-up Configuration.
Select the user defined configuration UserSet 4 as
UserSet4
the Power-up Configuration.
Linea Lite GigE Series Camera
Beginner
Beginner
DFNC
Beginner
DFNC
Beginner
DFNC
Beginner
Beginner
Beginner
Beginner
Beginner