Features; Display And Indicators; Buttons - Banner Q5X Instruction Manual

Features

The Q5X Laser Triangulation Sensor has three major features.
Q5X Features
2
1

Display and Indicators

The display is a four­digit, seven­segment LED. Run mode is the primary view displayed.
For 1-PT, 2-PT, BGS, FGS, and DYN TEACH modes, the display shows the current distance to the target in centimeters. For
Dual TEACH mode, the display shows the percentage matched to the taught reference surface. A display value of 999P indi­
cates the sensor has not been taught.
Display in Run Mode
1
STB 2-PT 1-PT MM
Output Indicators
• Ch1: On when the displayed distance is within the
taught analog output window
• Ch2: On when the displayed distance is within the
taught discrete output window
Stability Indicator (STB)
• On—Stable signal within the specified sensing
range
• Flashing—Marginal signal, the target is outside the
limits of the specified sensing range, or a multiple
peak condition exists
• Off—No target detected within the specified sensing
range

Buttons

Use the sensor buttons (SELECT)(TEACH), (+)(CH1/CH2), and (-)(MODE) to program the sensor.
June 22, 2023
Q5X Laser Triangulation Sensor With Analog Outputs And IO-Link Instruction Manual
3
1. Two output indicators (amber)
Display
2.
3. Buttons
2
© Banner Engineering Corp.
Stability Indicator (STB—Green)
1.
Active TEACH Indicators
2.
◦ 2­PT ­ Two­Point TEACH (Amber)
◦ 1­PT ­ One­Point TEACH (Amber)
Display value indicator (MM ­ Amber)
3.
Active TEACH Indicators (2PT and 1PT)
• 2­PT on—Two­point TECH mode selected (default)
• 1­PT on—One­point TEACH mode selected
Display Value Indicator (MM)
• On—Display shows the distance in millimeters (de­
fault)
• Off—Display shows the analog output value
• Toggle off the MM light by pressing SELECT when
the sensor is in run mode. This changes the display
to show the analog output value. Press SE­
LECT again to show the distance value.
7