Introduction; Features; System Description - Banner LS2e30-300Q8 Instruction Manual

2 Introduction

2.1 Features

2.2 System Description

NOTE: This manual refers to an emitter and its receiver, and their cabling as "a System".
Banner EZ-SCREEN Type 2 emitters and receivers provide a redundant, microprocessor-controlled, opposed-mode
optoelectronic "curtain of light", or "light screen". EZ-SCREEN Type 2 typically is used for point-of-operation safeguarding,
and is suited to safeguard a variety of lower-risk machinery.
The EZ-SCREEN Type 2 is a two-piece (two-box) system comprising an emitter and a receiver, but no external controller.
The external device monitoring (EDM) function ensures the fault detection capability required by EN ISO 13849-1 Category
2.
The EZ-SCREEN Type 2 emitters have a row of synchronized modulated infrared (invisible) light-emitting diodes (LEDs) in
a compact metal housing. Receivers have a corresponding row of synchronized photodetectors. The light screen created by
the emitter and receiver is called the defined area; its width and height are determined by the length of the sensor pair
and the distance between them. The maximum range is 15 m (50 ft), which decreases if corner mirrors are used.
Resolution is 30 mm (1.18 in).
Both emitter and receiver feature LEDs to provide continuous indication of the System's operating status, alignment and
error conditions.
In typical operation, if any part of an operator's body (or any opaque object) of more than a pre-determined cross section
is detected, the solid-state Output Signal Switching Device (OSSD) safety outputs turn OFF. These safety outputs are
connected to the guarded machine's Final Switching Devices (FSDs) that control the machine primary control elements
(MPCEs), which immediately stop the motion of the guarded machine.
Both OSSD outputs must be connected to the machine control so that the machine's safety-related control system
interrupts the circuit or power to the MPCEs (Machine Primary Control Elements), resulting in a non-hazardous condition.
Each OSSD is capable of sourcing 0.5A at +24V dc.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
• An optoelectronic safeguarding device
• Creates a screen of synchronized, modulated infrared sensing beams.
Choose from 10 sizes, in 150 mm (6 in) increments: defined areas from
150 mm to 1.8 m (6 in to 71 in)
• Compact package for smaller production machines
• Models available with Trip or Latch output operation (automatic or manual
start/restart)
• 30 mm (1.18 in) resolution
• Remote Test input terminals for simulating a "blocked" condition
• Operating range up to 15 m (50 ft)
• Type 2 per IEC 61496-1/-2; Category 2 PLd per EN ISO 13849-1
• FMEA tested according to IEC 61496-1, Type 2 requirements
• Receiver LEDs provide system status and emitter/receiver alignment
indications
• Highly immune to EMI, RFI, ambient light, weld flash, and strobe light
• Two-piece design
• Vibration-tolerant, factory burned-in emitter and receiver circuitry for
toughness and dependability
®
EZ-SCREEN Type 2 Light Screen