Troubleshooting; Contact Us; Fcc Part 15 Class A - Banner Q5X Instruction Manual

Q5X Laser Triangulation Sensor With Analog Outputs And IO-Link Instruction Manual
Chapter Contents

Troubleshooting ................................................................................................................................................................................................ 55

Contact Us......................................................................................................................................................................................................... 55

FCC Part 15 Class A ......................................................................................................................................................................................... 55

Industry Canada Class A................................................................................................................................................................................... 56
Banner Engineering Corp Limited Warranty ..................................................................................................................................................... 56
........................................................................................................................................................................................................................... 56
Chapter 8
Troubleshooting
Use the following table to correct any error codes that appear in the Q5X.
Error Codes
Error Code
Contact Us
Banner Engineering Corp. headquarters is located at: 9714 Tenth Avenue North | Minneapolis, MN 55441, USA | Phone: + 1
888 373 6767
For worldwide locations and local representatives, visit www.bannerengineering.com.
FCC Part 15 Class A
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Op­
eration of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to
correct the interference at his own expense.
June 22, 2023
Product Support and Maintenance
Description
No valid signal in range Reposition the sensor or the target
Reposition the sensor or the target to increase the detection
The signal is saturated
distance, or increase the angle of incidence between the sen­
(too much light)
sor and the target
EEPROM fault Contact Banner Engineering to resolve
Laser fault Contact Banner Engineering to resolve
Check the wiring for an electrical short circuit and to ensure
Output short­circuited
that the wiring is correct
System fault Contact Banner Engineering to resolve
© Banner Engineering Corp.
Resolution
55