Table of Contents
Advertisement
•
Request/Reply
•
Sender IP Filter
•
Sender IP Address
•
Sender IP Mask
• Target IP Filter
• Target IP Address
• Target IP Mask
• ARP Sender MAC
Match
• RARP Target MAC
Match
• IP/Ethernet Length
■
RARP: Frame must have ARP/RARP opcode set to RARP.
■
Other: Frame has unknown ARP/RARP Opcode flag.
Specify the available ARP/RARP opcode (OP) flag for this ACE.
■
Any: No ARP/RARP OP flag is specified. (OP is "don't-care".)
■
Request: Frame must have ARP Request or RARP Request OP flag set.
■
Reply: Frame must have ARP Reply or RARP Reply OP flag.
Specify the sender IP filter for this ACE.
■
Any: No sender IP filter is specified. (Sender IP filter is "don't-care".)
■
Host: Sender IP filter is set to Host. Specify the sender IP address in the
SIP Address field that appears.
■
Network: Sender IP filter is set to Network. Specify the sender IP address
and sender IP mask in the SIP Address and SIP Mask fields that appear.
When "Host" or "Network" is selected for the sender IP filter, you can enter a
specific sender IP address in dotted decimal notation.
When "Network" is selected for the sender IP filter, you can enter a specific
sender IP mask in dotted decimal notation.
Specify the target IP filter for this specific ACE.
■
Any: No target IP filter is specified. (Target IP filter is "don't-care".)
■
Host: Target IP filter is set to Host. Specify the target IP address in the
Target IP Address field that appears.
■
Network: Target IP filter is set to Network. Specify the target IP address
and target IP mask in the Target IP Address and Target IP Mask fields that
appear.
When "Host" or "Network" is selected for the target IP filter, you can enter a
specific target IP address in dotted decimal notation.
When "Network" is selected for the target IP filter, you can enter a specific target
IP mask in dotted decimal notation.
Specify whether frames can hit the action according to their sender hardware
address field (SHA) settings.
■
0: ARP frames where SHA is not equal to the SMAC address.
■
1: ARP frames where SHA is equal to the SMAC address.
■
Any: Any value is allowed ("don't-care").
Specify whether frames can hit the action according to their target hardware
address field (THA) settings.
■
0: RARP frames where THA is not equal to the SMAC address.
■
1: RARP frames where THA is equal to the SMAC address.
■
Any: Any value is allowed ("don't-care").
Specify whether frames can hit the action according to their ARP/RARP
hardware address length (HLN) and protocol address length (PLN) settings.
319
User's Manual of IGS-10020HPT-U
Advertisement
Table of Contents
