Table of Contents
Advertisement
2.5 Installing the batteries
Remove the battery cover from the remote control and put 2x AAA size batteries inside the
compartment.
The diagram inside the battery compartment shows the correct way to install the batteries.
1. Open the cover
2. Install batteries
3. Close the cover
NOTE:
2.6 Using the remote control
To use the remote control, point it towards the front of the digital receiver. The remote control has a
range of up to 7 metres from the receiver, if properly aligned towards the IR eye on the front panel.
The remote control will not operate if its path is blocked.
Note:
3.0 CONNECTIONS
3.1 Basic connection using an HDMI cable
a), Connect the LNB of your satellite antenna to the SAT IN connector of your receiver using a good
quality coax cable and suitable 'F-connector' plugs.
b), Connect one end of a good quality HDMI cable to the HDMI output on your receiver and the other
end to the HDMI input of your TV.
c), Plug the power adapter to a suitable wall outlet.
3.2 Basic connection using a Scart cable
a), Connect the LNB of your satellite antenna to the SAT IN connector of your receiver using a good
quality coax cable and suitable 'F-connector' plugs.
b), Connect one end of a good quality Scart cable to the TV SCART connector on your receiver and
the other end to the SCART input of your TV.
c), Plug the power adapter to a suitable wall outlet.
3.3 Connecting multiple fixed LNBs using a DiSEqC switch
a), Connect the LNBs of your fixed antenna to the inputs of a DiSEqC switch
The batteries should not be recharged, disassembled, electrically short-
circuited, be mixed or used with other types of batteries.
Sunlight or very bright light might decrease the sensitivity of the remote
control.
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
7
Advertisement
Table of Contents
