Xerox Phaser 4600 Service Manual page 76

09-589-00 Waste Toner Cartridge Full RAP
09-589-00 The Waste Toner Full Sensor indicates the cartridge is full.
BSD-Reference:
WD 7
Initial Actions
• Replace the Waste Toner and Toner Cartridges.
• Check for dust covering the sensor window on the cartridge.
Procedure
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Replace the Waste Toner and Toner Cartridges. The error message is displayed.
Y N
Reassemble and perform SCP 6 Final Actions.
28.3) and check sensor harness connections and condition. The
Remove the Left Cover (REP
harness is clean, connected and undamaged.
Y N
Repair or reconnect the harness.
28.2) and reseat CN2 on the MCU Board. The
Remove the Right Cover (REP
sage is displayed.
Y N
Reassemble and perform SCP 6 Final Actions.
Replace these components in order until the error is corrected.
1. Waste Toner Full Sensor, PL 9.15 Item 5
2. Joint Board, PL 9.15 Item 7
3. MCU Board, PL 3.10 Item 3
2 Status Indicator RAPS
09-589-00, 09-590-00
WARNING
09-590-00 Waste Toner Cartridge Not Installed RAP
09-590-00 The Waste Toner Cartridge Detect Sensor indicates the Waste Toner Cartridge is
not installed.
BSD-Reference:
WD 7
Initial Actions
• Check the actuator on the Waste Toner Cartridge Door.
Procedure
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Check the condition of the actuator on the Waste Toner Cartridge Door. The
undamaged.
Y N
Repair or replace the waste toner cartridge cover,
Check the function of the waste toner port on the Waste Toner Cartridge. The
opens when actuated.
Y N
Repair of replace the Waste Toner Cartridge.
error mes-
Remove the Left Cover
harness is clean, connected and undamaged.
Y N
Repair or reconnect the harness.
Remove the Right Cover
sage is displayed.
Y N
Reassemble and perform
Replace these components in order until the error is corrected.
1. Waste Toner Cartridge Detect Sensor,
2. Joint Board, PL 9.15 Item 7
3. MCU Board, PL 3.10 Item 3
04/2016
2-52
WARNING
PL 28.10 Item 2
28.3) and check sensor harness connections and condition. The
(REP
28.2) and reseat CN2 on the MCU Board. The
(REP
SCP 6 Final Actions.
PL 9.15 Item 6
Phaser 4600/4620/4622 Printer Service Manual
actuator is
port cover
error mes-
Revised