Xerox Phaser 4600 Service Manual page 34

03-335-00 Configuration Card Not Configured RAP
03-335-00 The Configuration Card did not initialize.
BSD-Reference:
WD 1
Initial Actions
• Reseat the Configuration Card.
• Cycle system power.
Procedure
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Cycle system power. The error message is displayed.
Y N
Complete.
Remove and inspect the Configuration Card. The card is undamaged.
Y N
Replace the Configuration Card.
Replace these components in order until the error is corrected.
1. Configuration Card, PL 3.10 Item 6
2. IP Board, PL 3.10 Item 2
2 Status Indicator RAPS
03-335-00 , 03-410-00
WARNING
03-410-00 Tray 2 Paper Mismatch RAP
03-410-00 Media size setting for Tray 2 differs from the media size reported by the Tray 2 Size
Switch.
BSD-Reference:
WD 3
Initial Actions
• Check media size settings for the tray from the Control Panel.
• Reset the tray side and rear guides.
• Check for obstructions blocking the Size Switch.
Procedure
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Cycle system power. The error message is displayed.
Y N
Complete.
Remove Tray 2 and inspect the Size Switch. The Size Switch is undamaged.
Y N
Replace the Size Switch, REP
Inspect the Tray 2 end guide. The end guide operates the Size Switch actuators.
Y N
Replace the Tray,
codes 07-220, 07-230, 07-240. The switches are operational (high/low).
Select dC330
Y N
Replace the Size Switch, REP
Replace these components in order until the error is corrected.
1. Size Switch, PL 3.10 Item 9
2. Tray, PL 7.10 Item 23
3. MCU Board, PL 3.10 Item 3
04/2016
2-10
WARNING
7.30.
7.30.
Phaser 4600/4620/4622 Printer Service Manual
Revised