Dc612 Print Test Pattern - Xerox Phaser 4600 Service Manual

Table 13 Output Codes 10
Code Display Name Description
10-400 Fuser Motor Forward Run Fuser Drive Assembly.
10-500 Rear Fan Run Run Rear Door Fan.
10-600 Fuser Bias Fuser bias voltage on at nor-
mal drive level.
10-900 Fuser Gap Motor Run the Fuser Release Drive
Assembly
Table 14 Output Codes 12
Code Display Name Description
12-100 Entrance Motor Run Finisher entrance motor
for about 5 sec.
12-110 Exit Motor Run Finisher Transport Motor
for about 5 sec.
12-120 Feed Motor Run Mailbox Transport Motor
for about 5 sec.
12-300 Front Jog Home Move right tamper to home
position
12-310 Front Jog Stand Move right tamper to stand
position
12-320 Rear Jog Home Move left tamper to home
position
12-330 Rear Jog Stand Move left tamper to stand
position
12-400 Support Finger Home Move supporter to home posi-
tion
12-410 Support Finger Stand Move supporter to stand posi-
tion
12-600 Stacker Down Lower Stacker Tray
12-610 Stacker Up Raise Stacker Tray
12-700 Stapler Staple when no cartridge
12-885 Diverter Motor Run entrance motor to actu-
ate exit gate
12-935 Upper Diverter Motor Cycle upper diverter between
three positions
12-955 Lower Diverter Motor Cycle lower diverter between
three positions
6 General Procedures and Information
dC330, dC612

dC612 Print Test Pattern

General
Purpose
On/Off
To print embedded test prints useful for troubleshooting print quality problems.
On/Off
1. Enter diagnostics, refer to
On/Off
2. Select Printer Routines, the DC612 Print Test pattern.
On/Off 3. Select the test pattern to print from those listed on the display.
General
On/Off
On/Off
On/Off
On
On
On
On
On
On
On
On
On
On/Off
On/Off
On/Off
04/2016
6-32
GP 1.
Phaser 4600/4620/4622 Printer Service Manual
Revised